There are many BSOD or Stop Errors here are some of the best ways to troubleshoot UNEXPECTED_KERNEL_MODE_TRAP stop error. Don’t forget to comment below if this helps to resolve your BSOD.

Cause – Hardware failure, like defective memory chips, mismatched memory modules, a malfunctioning CPU, or a failure in your fan or power supply are the probable reasons for this BSOD. (Also occurs if you overclock your CPU.)

Resolution –

Sometimes a simple Restart is all that is necessary to clear this error.

If you overclocked your PC recently consider Defaulting your CMOS settings.

Sometimes this error may be caused because of dust or carbon covered PCI components like external LAN cards, TV tuner cards, etc.

Remove them and clean them also remove the drivers from Safe Mode.

(For PCs with dual-channel RAM or multiple sticks of RAM)

Shut your PC off.

Remove a single stick of RAM and power your PC back on.

(Note – If you have the same Stop Error shut your PC down and try replacing the next stick of RAM.)

Check inside your PC verify ALL System Fans & CPU Fans are Operating.

Check your Power Supply Unit – PSU with a multi-meter or Replace the PSU

This concludes all the steps for troubleshooting BSOD UNEXPECTED_KERNEL_MODE_TRAP

Check out by other BSOD troubleshooting guides here!

%d bloggers like this: